Allmand-brothers 15-20 V - MLV15-20 HYDRAULIC Manuel d'utilisateur

11ML 15/ML 20OPERATOR’S MANUALALLMAND BROS. INCP.O. BOX 888HOLDREGE, NE 68949PHONE: 308/995-4495, 1-800/562-1373ALLMAND FAX: 308/995-5887ALLMAND PART

HYDRAULIC TOWER POWER UNIT GENERAL START UP INSTRUCTIONS NOTE: The ports are marked on the casing UP and DN. When facing the power unit with the mo

101011TOWING INSTRUCTIONSBefore towing the MAXI-LITE the trailer should be inspected visually to insure that the following operations have been comple

1212STARTING THE ENGINENOTE: The Isuzu engine includes a glow plug cold start system controlled by the ignition switch on the control panel. Glow plug

121213SERIAL NUMBER LOCATIONSTrailer: All MAXI-LITE ML 15/ML 20 V-SERIES models have a serial number plate located on the lower left corner of the r

1414MAXI-LITE DIMENSIONSHeight lowered: 7’8” (2.34 m)Height extended: 25’6”’ (7.8 m)Length:

141415SPECIFICATIONSLow oil pressure, high engine temperature shut-downs and a glow plug cold start assist arestandard equipment on the Isuzu 4LE1 die

1616GENERATOR15 kW single phase and 20 kW single and three phase models available60 hz and 50 hz models available (50 hz 15 kW only) FUEL REQU

161617CONTROLS AND COMPONENTSNOTE: PHOTOGRAPHS MAY SHOW NON-STANDARD EQUIPMENT AND OPTIONSFIG. 1. AC CONTROL PANELFAILURE TO UNDERSTAND AND COMPLY W

1818CONTROLS AND COMPONENTSNOTE: PHOTOGRAPHS MAY SHOW NON-STANDARD EQUIPMENT AND OPTIONSFIG. 3 BALLAST PANEL11. Ballast, Capacitors 1 through 412. Bal

181819CONTROLS AND COMPONENTSNOTE: PHOTOGRAPHS MAY SHOW NON-STANDARD EQUIPMENT AND OPTIONSFIG. 5 GROUND ROD (Optional)16. Ground Rod Ground Rod sho

22INSPECTION CHECK LISTFOR PREPARING THE MAXI LITE FOR DELIVERY OR RENTALThe MAXI LITE V-SERIES requires service as well as proper operation in order

2020CONTROLS AND COMPONENTSNOTE: PHOTOGRAPHS MAY SHOW NON-STANDARD EQUIPMENT AND OPTIONSFIG. 8 REAR JACK28. Rear JackFIG. 9 OUTRIGGER JACK29. Pin-

202021CONTROLS AND COMPONENTSNOTE: PHOTOGRAPHS MAY SHOW NON-STANDARD EQUIPMENT AND OPTIONS4039FIG. 10 TONGUE ASSEMBLY35. Taillight Wiring Harness36.

2222CONTROLS AND COMPONENTSNOTE: PHOTOGRAPHS MAY SHOW NON-STANDARD EQUIPMENT AND OPTIONSFig. 13. Hydraulic Bypass Valve 41. Bypass Valve Allows

222223CONTROLS AND COMPONENTSNOTE: PHOTOGRAPHS MAY SHOW NON-STANDARD EQUIPMENT AND OPTIONSFIG. 15 Cord Reel45. Cord reel —Manages the mast power cabl

2424CONTROLS AND COMPONENTSNOTE: PHOTOGRAPHS MAY SHOW NON-STANDARD EQUIPMENT AND OPTIONSFIG. 18 Light Bar and Mounting Locations1. Light Bar2. Light m

242425ROUTINE MAINTENANCEISUZU 4LE1 INSPECTION, MAINTENANCE, AND LUBRICATION SCHEDULECheck condition of the steel tower cables and make sure they are

26TROUBLESHOOTINGDANGER!HIGH VOLTAGE! DO NOT ATTEMPT TO TEST AND REPAIR GENERATOR AND BAL-LAST ELECTRICAL SYSTEMS UNLESS YOU UNDERSTAND AND ARE QUALI

223INSPECTION CHECK LIST ...2TABLE OF CONTENTS ..

44This manual provides the information necessary for the safe operation of the Allmand Bros., Inc., MAXI-LITE V-SERIES light tower.The MAXI-LITE V

445SAFETY AND WARNING DECALSSAFETY WARNINGALWAYS REPLACE ANY SAFETY AND INSTRUC-TION DECALS THAT BECOME DAMAGED, PAINT-ED, OR OTHERWISE ILLEGIBLE.

66SAFETY AND WARNING DECALSPART NO. 090158Location: AC control panelPART NO. 090166Location: Inside left hand door panelPART NO. 090163Location: On l

667SAFETY AND WARNING DECALSPART NO. 101057Location: On fuel tank near ller neck.PART NO. 090465Location: Inside left door panel.PART NO. 100247Loc

88HYDRAULIC LIFT VERTICAL MAST OPERATIONDESCRIPTION OF OPERATIONThe Allmand MAXI-LITE V Series hydraulic lift tower assembly consists of a seven sec-t

889HYDRAULIC LIFT VERTICAL MAST OPERATION VISUALLY INSPECT EQUIPMENT FOR DAMAGE BEFORE OPERATING. ALLOW ADEQUATE CLEARANCE AROUND TRAIL-ER FOR TOWE